The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
have just finished wheat harvest in Australia with a new 7088 400 rotor hours, very happy with the machine. Had to adjust rotor cage veins to get capacity, has anyone else experienced this as it was a bit different than a 2588.
 

· Registered
Joined
·
42 Posts
Discussion Starter · #4 ·
RGP. Do you know the reason why you have to adjust rotor settings compared to previous 88 models. We were running a small wire and two large, the first six veins over concaves in slow position and the last three over grates in the fast position. We have never had to adjust the veins from the middle position before with previous 21 to 2588 models and these changes doubled the capacity, was hopeless without these adjustments.
Does anyone know the setup for the 7088's in rice with a small tube rotor and will be using a 25ft macdon, any advice would be greatly appreciated.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top