The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter #1
7120 owners check your bottom clean grain augers. Weld broke on the shaft ,that the bottom elevator spocket attaches to. Where the shaft goes into the auger. Weld was off target.
 

·
Registered
Joined
·
3 Posts
I guess we are not the only ones that had this happen on a 7120. Same deal with the weld missing the target. Dealer had us up and running after a few hours of down time.
 
1 - 2 of 2 Posts
Top