The Combine Forum banner

7120 repairing cone in front of rotor cage

2037 Views 3 Replies 2 Participants Last post by  325mag
My 7120 has worn a hole in the cone in front of the rotor cage. I haven't talked to a mechanic directly, but it sounds like this is built into the machine and must be patched in place. The machine has about 750 separator hours.

How have you accessed this area, and how have you patched the hole?
1 - 2 of 4 Posts
I would suspect it is the right side just in front of the concave?
You are correct for location.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.