The Combine Forum banner

7120 repairing cone in front of rotor cage

2060 Views 3 Replies 2 Participants Last post by  325mag
My 7120 has worn a hole in the cone in front of the rotor cage. I haven't talked to a mechanic directly, but it sounds like this is built into the machine and must be patched in place. The machine has about 750 separator hours.

How have you accessed this area, and how have you patched the hole?
1 - 2 of 4 Posts
Left side, right side, top, or bottom? I would suspect it is the right side just in front of the concave?
A new cone will most likely fix it.
A new cone will fix the problem then. Just not enough room to weld a patch in.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.