The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9,738 Posts
Discussion Starter · #1 ·
I am having electrical problems with the mfwd solenoid has low voltage, wires unhooked I have about 1 volt below battery voltage, hook up the wires to it and check the voltage on the positive wire and nothing, 11 ohms on the solenoid. Good voltage in the cab, switch was recently new and checks good. Duoich connector looks good under the cab so I followed the harness into never never land. Does anyone have a pinout diagram for the connector under the cab? Any help greatly appreciated!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top