[wickedme45]

Hey thanks for reading..

Currently have a 7720 t2 4wd / with 8820 motor

Just purchased a 925 for it

Having problems keeping this prick cool.

Temperature is creeping up to 205 206

thats just casually driving down a clean field at approx 3.5

I have cleaned and flushed everything on this pump is fine thermostates are opening its completly clean of dust dirt what ever

So today i purchased a new rad Only thing I could think off

1400 canadian later ill have it tomorrow

just wondering anyones input on this as the only conclusion i can make is that the rad bars are plugged..

thanks

 

[boomer]

205-206? Unless it gets over 220 while working it I wouldnt worrie about it. How hot is it getting working it?

 

[mike52ar]

is the belt tensioner stuck a bit? i have seen it on mine when the belt warmed a bit that it was loose and the fan lost some speed. turned out the tensioner did not have quite a full range of motion to it.

 

[mike52ar]

by 8820 motor do you mean equipped with a water to air intercooler?

 

[wickedme45]

Yessir

 

[wickedme45]

when its working its gettin up to 205-210 area roughly

from what deere is saying and my guage that is tooo hot..

just installed the new rad today just got out of my shop will take it for a spin tomorrow see how many leaks i have lol none i hope


ill keep ya posted

 

[Tom Turner]

Take a heat gun to check temperature

 

[hogman2002]

Are you sure your gauge is correct? Is your airfilter clean? What about your lower radiator hose. Make sure it still has the wire in it. If it doesn't, it's probably collapsing and limiting coolant flow. Also check the tensioner like Mike said.

 

[wickedme45]

Hey thanks for all the replys.. My problem is now solved it must have been the rad put a new one in and all day it ran at the highest point of 190 which is perfect.

I actually put a new gauge in. ..... One with numbers lol