Looking at fitting one or both of these to my 7720 turbo. Wondering if anyone has any comments or feedback as to what brands have been used and how well these have performed as well as the time required (and$$$) to do this?
i just bought tsr fine cut choppers for my 8820s wont know for a month and a half yet how they do!!! i also bought a crary chaff spreader for my combine it was pretty reasonable !! my chopper was 3450 us dollars deliverd to my dealer!!!!thats a complete fine cut unit ready to mount on my combine minus the drive pulley system and the driven pulley on the choppper!!
We harvested some tropical grass seed last year using a neighbours JD 9500 with a 925R front. The seed is an extremely light seed however we did put the fan on and came out with quite a good clean sample (realising we were blowing a fair bit out the back).
This year we are looking at...
Hey I have a 9670 with a very sloppy turbo actuator linkage it's a simple little rod but jd seems to think it's worth 770 bucks for something I can hold in my hand . Does anyone know where i can get one alot cheaper? Any feed back is appreciated thanks.
I have a 2008 John Deere 9530 four wheel drive, During maintenance this spring I found almost a handful of steel filings in the front differential. It is a well cared for unit andwas wondering what caused the bearings to go. Was never low on oil and Never pulled a scraper. Tranny and back...
I’m trying to track down a widening kit for an 8430t. I read a bunch of forums that said their used to be a company called Lean Technologies out of North Dakota that did it, but they’re closed now. Anyone have any ideas?