The Combine Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
5,773 Posts
Discussion Starter · #1 ·
I have a 04 CR970 and need some help with the EZ steer settings. 8010s are pretty similar and hopefully could get me going at least.

The stuff off the trimble site isn't working for me.

Thanks
 

·
Registered
Joined
·
475 Posts
Ignore the setting you see on the site- they most likely are for an EZ Guide Plus. With a 500 or 250 on an EZ Steer, just physically measure the combine (or tractor or whatever you are installing on) and use those measurements. Start the calibration wizard and follow the steps. PM if you have questions.
 
1 - 4 of 4 Posts
Top