The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
I don't know what going on with it sometimes it works fine but most of the time its says low fuel [ just filled it up] it comes and goes and you have to touch the monitor everytime. It is very annoying, it beeps every time. Is it the sensor or wiring. Its says bout 1 volt when I go to dignostics.
 

·
Registered
Joined
·
106 Posts
there was an update to replace all fuel tanks and sending units on older 8010's. If it was done, I would imagine all it is is the sending unit anyhow.
 
1 - 2 of 2 Posts
Top