The Combine Forum banner
1 - 1 of 6 Posts

· Registered
1 Posts
It will fit. When we had an 8010 we pivoted the chopper up out of the way, then drill all the rivets that hold the rubber seals on the sides of the upper sieves. Remove the rubber seals and it will slide in the back. It's tight, but fits. Did ours this way and also helped a neighbor do his the same way. It's not that bad, just need two sets of hands.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.