The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 · (Edited)
SYMPTOMS- After a successful rotor calibration the combine keeps stating to complete a rotor calibration. Will keep stating the same message even after multiple attempts.
REPAIR- Remove the front bearing cover and place a piece of rubber under the rotor bushing. Wedge a block of wood between the piece of rubber and the frame. This will provide enough resistance to prevent the rotor from spinning due to clutch drag during the calibration. Perform a rotor calibration.
Plant Automotive tire Automotive lighting Motor vehicle Hood

7010 8010 7120 8120 9120
 
1 - 1 of 1 Posts
Top