The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I haven't done this yet, but will later on this year (our harvest starts in late Oct or early Novenber). I think the only way to do it is to use a NMEA out cable from the mojo into the Pro600 screen, to supply position info for yield mapping in the Pro600. Then to autosteer the 8010, you need a "Steer Ready Kit" that suits this vehicle type, to control the valve, read the steer angle sensor etc (takes the place of the Nav2 controller and is cheaper too!) Then you should be ready to go.
 

·
Registered
Joined
·
7 Posts
Anyone hooked up a Leica mojo to a 8010? I want to yield map and not sure whether it is simpler to take GPs from mojo to AFS or yield data from AFS to mojo. Any ideas?
 

·
Registered
Joined
·
7 Posts
Thanks southoz, I had the feeling Leica isn't ready to do yield mapping so will have to get the GPS data from it to the AFS. The 8010 doesn't have any of the guidance or pro 600 so will use an Ezisteer.
 
1 - 3 of 3 Posts
Top