The Combine Forum banner

8010 Rotor Cone Wear

1981 Views 2 Replies 3 Participants Last post by  MI CASEIH
I was just wondering what kind of cone wear and feeder sprocket wear you guys are getting on your 8010's dealer today told me that it's pry about time for mine to be replaced without looking at it yet I have roughly 1100 sep hours on it.... On our 2388's I seen them go 3 to 4 thousand hours before replacing them.. We see generally 80% wheat and 20% fall crops in our area though these machines.. Thanks in advance
1 - 3 of 3 Posts
Couple of factors here. The 8010 and 2388 are almost entirely different machines (NH in origin) and the 8010 has higher throughput. You will have to replace components and address certain areas sooner or with greater frequency with the higher throughput rate, but in addition, there are areas such as this that are built a bit on the lighter side. Other areas you'll want to put your eyes on would be grain tank auger bottoms; unloader elbow and tubes; clean grain (and to lesser extent tailings) bottom cross auger troughs; elevator boot and head; fountain auger/tube (probably already done); chopper bearings; various belt idlers and bushings; feeder floor - these are just areas to call special attention to for wear in addition to your normal inspection of the processing components of the machine.
Couple of factors here. The 8010 and 2388 are almost entirely different machines (NH in origin) and the 8010 has higher throughput. You will have to replace components and address certain areas sooner or with greater frequency with the higher throughput rate, but in addition, there are areas such as this that are built a bit on the lighter side. Other areas you'll want to put your eyes on would be grain tank auger bottoms; unloader elbow and tubes; clean grain (and to lesser extent tailings) bottom cross auger troughs; elevator boot and head; fountain auger/tube (probably already done); chopper bearings; various belt idlers and bushings; feeder floor - these are just areas to call special attention to for wear in addition to your normal inspection of the processing components of the machine.
We manufacture liners for all the wear parts on the Flagship & Midrange Combines .Transition cones, grain bed liners, clean & return grain liners, vertical unload auger liners, hard surfaced augers and a lot more. Check us out at. www.ihlefabrications.com
Your Combine Auger Liner Specialists
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top