The Combine Forum banner

8010 saving straw

911 Views 1 Reply 2 Participants Last post by  redhat
Wondering if anyone has had luck saving straw in HRRWW/SW with an 8010 and not losing too much capacity or grain loss from rotor? If so, what setup/settings are used?
1 - 2 of 2 Posts
Sm wire concaves all 4, Round bar concaves in the rear all 4, concave 1-1.5, rotor 900rpm, fan 800-880 tops, 1-5/8 chaffer @14, 1-1/8 sieve @13, pre-cleaner set one notch from the top.
36ft draper, 105 bu/acre dry avg, 3.7-4.0 mph, clean sample 0.01 dockage, 18% moisture, loss monitor in green on rotor and sieve, under 0.75% on the ground.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top