The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter #1
I need to get the GPS signal from the Autofarm into the Pro 600 in a 8120 combine to run the yield monitor. Can any one tell me where the connector is and what pin number is the GPS in and any settings needed in the Pro 600. Thanks.
 

·
Registered
Joined
·
560 Posts
10-pin Metripack connector in or hanging out the bottom of the right-hand console. This is called RS232A in the Pro600. Pin E is the Display Rx wire. Set your receiver to output NMEA at 38k4. 8 data bits, 1 stop bit, no parity (N).
 
1 - 3 of 3 Posts
Top