The Combine Forum banner
Cancel

8120 Calibrate header ground height sensors

8609 Views 5 Replies 4 Participants Last post by  torriem, 
S
Hello has anybody had this message pop up on monitor? CALIBRATE HEADER GROUOND HEIGHT SENSORS. I did a feeder calibration with header off, then I attached the MacDon D60 header and lowered it to the ground for 3 seconds then all the way up and it still doesn't fix the issue. I attached the combine to the pickup header and the message disappears. As soon as I unhook pickup head the message comes back. I can't figure this one out. Any ideas? Thanks
Reply
Save
Like
1 - 1 of 6 Posts
H
make sure the combine recognises the changed head in Header 1 set up screen
Also do the calibration with the header running and see how you go assuming you have the hydraulic ram for fore /aft tilt and float on the adaptor .
if it aborts you have to make sure the voltage is within spec at either end of the float and adjust if needed
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Combine Forum
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
John Deere Tractors Planting & Tillage Case IH Crop Production
Top