The Combine Forum banner

8230 in Soys

1414 Views 2 Replies 3 Participants Last post by  Darrell S
What is the typical config for concaves in soys? I typically run large wire in the back 2 spots and small wire in the front for small grains and canola. I have been told pull half the wires from the small wire concaves and put them to the back and run the large wire in the front two spots, is this a general concensus?

What about running all 4 as large wire?

Or leave the large wire in the back and just pull the wires in the small wire and leave them in the front?
1 - 1 of 3 Posts
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.