The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Recently purchased a 8240 combine. It seems like most 8240’s I have seen have about a 6 foot unloading auger extension (standard?). Will this be long enough to put a 45’ head on my combine or will I need another extension or at the least a pivoting spout? Thanks in advance!
 

·
Registered
Joined
·
3,826 Posts
I believe the standard auger length on the 8240 is 28'9", measured from the center of the combine. I'm pretty sure the 6' extension is considered the "standard" auger. That might just barely be enough for a 45' header but you'd be driving pretty close to the truck.
 
1 - 4 of 4 Posts
Top