The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I changed the axle tube, there was no thrust washer on the end of axle between the planitary gears.
I can see this housing did have the punch marks to hold a washer in at some point.
I did put a washer in but it squeezes axle enough that it burnt the paint off the planetary, just driving up and down the field once. Does anyone know if this washer is supposed to be tight and wear down? or should I just take it out?
 
1 - 2 of 2 Posts
Top