The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
Machine clutch not kicking in. Rotor turns on. Fuse is good and switched relay in the electrical cabinet behind the seat. No broken wires on clutch. What do I need to do to check relay by the clutch? Where does it get its power from? Can I check for power with engine off?
 

·
Registered
Joined
·
977 Posts
Did you take the cover off of the piece on the very end center of the shaft that the wires go into, to actuate the clutch , had issues with bad connections in there before . And yes you can check for power with engine off and kjey and thrasher on .
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top