The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
we got both our 9120's and put the heads on and tried to lift them but they only went about half way and stopped ....waited a few seconds and tried to raise again and it went the rest of the way up!! i know it will lift it cause we have the big cylinders and lift speed turned all the way up...what do i not have set right
also when i go to let it down it drops to fast and i have the lower speed set on 10 what else can i change???
thanks pjhfarms
 

·
Premium Member
Joined
·
1,249 Posts
needs ground cal or hold the button to set header height down til light goes out in each position will clear the settings. FT
 

·
Registered
Joined
·
102 Posts
Have your dealer reset the feeder lift configuration to 76mm cylinders instead of the 90. This has to be done with the electronic service tool but it fixed mine.
 
1 - 6 of 6 Posts
Top