The Combine Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter · #1 ·
What do you guys use for modules in milo for 9120 our dealer told us to use small wire in front two,large wire in second , and skip wire in last two. And to run 4 straight bars, which i dont think we need. Can always get good sample but always have huge tailings volume like 70 80 percent!!! Don't have other settings here but I will get if needed. "Finishing drilling wheat"
 

·
Registered
Joined
·
1,603 Posts
For us, itch weed is the last thing to harvest. By that time we are about all done in and we just don't care as much as when harvest is just starting. And there are few enough acres the settings don't get time to get burned into the brain.

As for tailings volume, that means little. You have to know what is in the tailings! Lots of grain, open the bottom sieve. Lots of fluff, close the top sieve, increase the air. Unthreshed grain, tighten the concaves, increase rotor speed.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top