The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
I have a 915 combine and I'am having problem with three shaft speed sensors working they are the fan, chopper, and rack they have magnets on them the wiring is fine and I've adjusted the fan nothing could the sensor it self be bad?
 

·
Registered
Joined
·
94 Posts
Yes have seen sensors go bad over the years. There are no magnets just a ferro core that interupts the electric field of the sensor as it goes by. Find some used ones or move one from a working positon and see if that cures the problem.

John
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top