[jpg4320]

I have a bracket broke on my cross-shaft that drives the rotary screen belt. I have it all loose. Trying to figure out how to get it out of there! Does the whole radiator box swing out? I even borrowed a tech manual, but all it shows for this is a parts break-down. Thanks in advance!

 

[jd9600guru]

Take pullies off both ends and use a 13mm gear wrench to remove the 4 flange nuts holding the brackets.

Try and work it so you can take it out the side by the door, if not, take the access panel off the inside of the grain tank and go that route.

Take note of the dimension of the outer bearing to the end of the shaft for easier reassembly.

jd

 

[deerecombinetech]

As aquard as it is, it can also be taken out on the engine side. If you can configure your body around the belts then this way is not to bad.....

 

[thecombiner]

never thought about taking the access door out of the grain tank,I stood on my head to reach the back bolts,thanks for the info