The Combine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Have the feeder house off replacing rasp bars, clean grain auger, tailings return auger, bearings and slip clutch on feeder house drive. I have already replaced concave, better grate, feeder house chain three years ago. I plan on keeping this machine for a few more years, any upgrades or recommendation I should be doing to this machine. It has 2400 separator hours on it. I heard about taking the filler plate out? I put new fluted ones in three years ago. Or about putting filler plates in the concave? It has been a good machine, just want to prevent some down time but improve performance. Thanks in advance! RR
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top