The Combine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
4 Posts
9560 sts trouble

I have a 9560 sts 2006 it has a vib in it and it is in when separator is ingaged. I have replaced rotor pulley engine grear case pulley that runs rotor drive shaft to primary gear case taken shaft out of prim gear case and squared on on lathe ....can run rotor and engine gear case without drive shaft is smooth I think its primary gear case but the pros say it is nature of beast give me back my 9500 any thoughts
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top