The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
The finished field to harvest, I unhook the cutting, the engine stops ? I start engine , rolls a little, the engine stop again with the code 072 E , I start again , engine run , I roll on the road with engine low , stop again ?

Thank
 

·
Registered
Joined
·
139 Posts
hello etienne, have had a few 9500's with same issue, are we talking early 1997 and older???machine, if so there is a black plastic cover on rear engine bay, this is where the ecu is located, remove cover, below ecu there is a small square circuit board with a circuit breaker on it, replace breaker, but also inspect circuit board for burns, or corrosin.72e codes are related to communications harness to tachometer circuit,with out this the combine will die as you have described, hope this will help, deerefever.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top