The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter #1
How wide is the 9600 with standard spacer duals? Is it possible to use a 6 row 30" on such a machine?
 

·
Registered
Joined
·
209 Posts
I seriously doubt that dual wheels would fit between a 6 row 30" frame. We run a 6 row 30" on our 8820 with 30.5 X 32's. It has axle spacers and the deep dish of the wheels are on the inside and it is the same width as the head. 6 rows is WAY to small for our 88, but it's what we have to work with for now. Probably too small for a 9600 too.
 

·
Registered
Joined
·
85 Posts
You can do this, I guess but you will need to take your duals off and have the centers cut out and re welded to change the offset of the duals. There is a man near Archbold, OH that can do this, but I cannot think of his name off the top of my head. Give me a day or so.

I just bought a 9600 with 30.5s, and its going to be right close with a 6 row on it, but its what I have.
 
1 - 3 of 3 Posts
Top