The Combine Forum banner
1 - 1 of 1 Posts

· Registered
778 Posts
Throw a 10000 psi gauge on the test DR's on the hydro motor. At full throttle hold the brakes and push the hydro lever all the way. You should see around 6600 to 6800 psi fwd and rev. If it's low, check/replace the pressure control valves in the endcap of the motor.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.