The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
We have a 2002 9650sts and the threshing speed reading suddenly went to 0. However, the rotor turns, the belt adjusts, the wiring appears good, and bearing is fine. I replaced the sensor, and it still reads 0. What other possibilities are there for a solution?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top