The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Been doing corn with our new to us 9650 and was wondering if there was a way to adjust the sensetivity of the shoe and rotor loss bar graphs. I have the center bar calibrated to where i want it and it works very well but when it starts to push grain the shoe and rotor graphs are dont go up at all. it would be nice to know where the loss was coming from. Very impressed with this machine so far.
 

·
Registered
Joined
·
23 Posts
Discussion Starter #2
Thanks. That was the info i was looking for. I had the center bar adjusted so when it reached the middle it was getting beyond acceptable loss. I assume i will need to adjust the number higher then to keep it the same.
 

·
Registered
Joined
·
26 Posts
This should help you out.. i do both these things on our combines to show more info in the visiontrak display


#1- independent shoe loss shows you the reading from each sensor separately

E02 address 102
value should be 2 for independent bars


#2 To change sensitivity

Right E02
104

DISPLAY/MODIFY: Shoe offset
Increase number to lower displayed level of loss.
Decrease number to raise displayed level of loss.

Range = 50 - 250

9650STS and 9750STS - Default = 80

All other combines - Default = 40

Right E02
105

DISPLAY/MODIFY: Separator offset
Increase number to lower displayed level of separator loss. Decrease number to raise displayed level of separator loss.

Range = 50 - 250

9650STS and 9750STS - Default = 80

All other combines - Default = 40
 
1 - 3 of 3 Posts
Top