The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Wheat harvest everything fine, sat for 2-3 weeks. Went to move it, corner display (all 3) has all symbols lit up, engine speed control stuck in low. Unhooked batteries overnight - all well. Sat till now- same thing - throttle worked until seperator engaged, then quit (low idle only - lights on console change by buttons) Greenstar, speed monitors, head height, unload, swing etc... ok. Unhooked batts for 1/2 hr, dielectric greased all cab connections, no change. Will let it set overnight and see. Any Ideas?
 

·
Registered
Joined
·
778 Posts
Check for active codes. Is the little wrench book icon flashing on the lower display? Maybe try disconnecting Greenstar components one at a time- they are notorious for causing problems like this.
 

·
Registered
Joined
·
289 Posts
Had a similar thing on a 9650STS. Turned out to be a corroded contact on the moisture sensor loading the can bus with garbage, shutting down header and throttle like you said.
 
1 - 4 of 4 Posts
Top