Does the 9660WTS have more capacity ie(larger bin, larger cleaning area) than a 9610 or is the only difference the beater on the walkers? Also do the WTS have a two speed cylinder drive to reduce the speed below 300...n e comments appreciated!!
9660WTS vs 9610
1 - 3 of 3 Posts
We found about a 10% increase form the 9650 we had, we have since traded for 9770 and I'm not sure I should have I really liked that WTS.
As for the 2 speed cylinder drive, I'm pretty sure it had one, never used it so I want to be careful I'm not confusing it with with the 9650.
As for the 2 speed cylinder drive, I'm pretty sure it had one, never used it so I want to be careful I'm not confusing it with with the 9650.
Joined
·
1,518 Posts
i went from a 9600 to a wts and would estimate a 10-15% increase in capacity. hopper is 310 bus by the op manual if i remember. engine has substantionaly more power. there are six walkers instead of 5....think the same area though. it does have a 2 speed cylinder. has single point hook up which is very handy and lots of bells and whistles...not sure if all that crap is good or bad
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Pattison foam lake
John DeereFirst dealership closes of the winter ? Saw this on twitter any reason this location is closing? I thought foam lake was a pretty strong farming area- 13
- 1K
-
KXE10163
John DeereHi Can anyone tell me if these vanes are used in the discharge beatter area . I am having trouble with a S670 throwing more material out the Right hand side and was wondering if these would help even the distribution of material out. Thanks- 0
- 48
-
9860STS engine won’t rev over 270RPM
John DeereI have a 9860 STS runs but only just at 270RPM checked fuel coming out of tank and screen there and fuel filters they seem ok, any other suggestions? What fuel pressure should I be getting at the filter housing? Any help much appreciated.- 7
- 351
-
D635 header height control
John DeereWe have 3 D635 and have always had lots of header height ground following issues. We have done lots of calibrations and changed sensors. Someitmes they work but for the most part we have to run manually. Any one have any solutions? We are thinking of trying headsight header height control.- 0
- 58
-
2630 display vs 4640 display in S670
John DeereConsidering purchasing 4640 display with auto track as opposed to activating auto track on the 2630 display. Any experience using 4640 display on combine?- 5
- 441
Join now to ask and comment!