The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 9750 sts the monitor in the cab will not give me a speed reading at all I have checked the senser on the rotor and the wiring to the cab all is good any ideas where to go next
 

·
Registered
Joined
·
94 Posts
My bet is that if the wiring is ok and the sensor is ok and adjusted properly that the cornerpost control unit is bad. I have replace many over the years for this very problem. To adjust the sensor screw it in until it touches the tone wheel and back it off two turns and lock it down. If that doesn't take care of it most likley it is the CPU.
 
1 - 3 of 3 Posts
Top