Joined
·
88 Posts
I have a 9760 and the seperator turn itself off after about 3 seconds. the only alarm is a discharge beater but beleive that is just the sensor.any ideas need help fast. Thanks
9760 seperator turns off
1 - 3 of 3 Posts
Joined
·
110 Posts
Check the sensor on the discharge beater. If the machine thinks its not turning it will stop the seperator. Make sure the magnets have not fallen out of the piece on the shaft. Check the plug good. Make sure sensor is tight on shaft. I have tapped gently the mounted piece and been able to finish the day. I would bet this could be your problem.
Good luck,
DeereCattopher
Good luck,
DeereCattopher
Joined
·
88 Posts
yep lost the sensor thank going again
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
JD 8820 reel speed problem
John DeereI'm currently using a 8820 turbo to harvest a light crop. The reel only turns slow (dial in cab does nothing). Any ideas where to look or if there's a valve I can adjust to get it turning faster.- 8
- 279
-
Pattison foam lake
John DeereFirst dealership closes of the winter ? Saw this on twitter any reason this location is closing? I thought foam lake was a pretty strong farming area- 2
- 308
-
Central AB, anyone turning crops?
John DeereWhat with all the rain, anyone planning on turning wheat or barley crops to dry faster?- 8
- 2K
-
John Deere 9500 Combine
John DeereWe have a John Deere Combine 9500. from 1996. What is the problem when you switch to to half engine speed nothing happens? it only work on idle and full speed.- 0
- 124
-
Jens Haslund-Thomsen · updated
-
I have a 2005 9660sts combine , the top of bottom seive is wearing on the bottom of top seive
John DeereEverything seems to be tight where they both mount but are wearing on each. It wore the crank assembly on the top completely off ? I wouldn't think they should even touch each other? Did take belt off to see if the back would turn freely even with the top out but turned very hard by hand . DID...- 0
- 120
Join now to ask and comment!