The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
Electric clutch & belt vib is very noticable ,drive for feeder house.I took belt off and can move clutch and shaft up & down about a quarter inch I would like to thank anyone for advice on what to look for.
 

·
Registered
Joined
·
400 Posts
the hub on the electric clutch. if it is worn excessively, it may be worn through the snap ring and into the bearing, in which case, you need to get a new clutch. but with only a 1/4" you might be ok

#15 - H236500

#17 - AH234499

 

·
Registered
Joined
·
32 Posts
Discussion Starter #3
Thankyou I took it apart and the hub looks egg shaped on the end. Does the hub center the shaft or do the splines center it all? the splines look to be worn slightly
 

·
Registered
Joined
·
400 Posts
perhaps, the grease lubes the splines on the driveshaft, the hub should still hold everything tight, not sure if its vibration or what that takes out the hub
 
1 - 6 of 6 Posts
Top