The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
i have a 9760sts that when you engage the seperator, it will run for about 1 min then kick itself back off. no codes. checked alternator, appears to be ok. switched unload auger engage solenoid back on main engine gearcase with the seperator engage, still same thing. put auger engage solenoid on seperator engage valve, hit unload auger button, seperator will stay running then. appears my hydraulics are ok. any other suggestions. thanks
 

·
Registered
Joined
·
585 Posts
Had this happen on our 9860. Check the connector on the main power line from the batteries to the starter. (you have to crawl down in front of the engine by the rotor sheives) I bet you the eyelet is cracked on the starter.
 

·
Registered
Joined
·
17 Posts
Discussion Starter #5
worked on this machine, found mice had chewed two wires up inside cab right inside cab wall connectors. thanks for the info.
 

·
Registered
Joined
·
109 Posts
I have a 9660 it is the contacts in the switch get dirty turn key off and turn the switch on and off 40 times that is what i was told by jd tech or to change the switch or swap with the header switch
 
1 - 6 of 6 Posts
Top