The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
on my command console. on the yield monitor page. the two bar graphs that tell you yield and moisture. there is nothing in my graph,blank. and the high yield and high moisture readings are crazy high, any thoughts
 

·
Premium Member
Joined
·
1,236 Posts
I'm thinking if your doing yield monitoring and or mapping on the 2600 then the command center will only show moisture and yield. It will show the graph. on the 2600. Have not been in a combine to see this.
 
1 - 4 of 4 Posts
Top