The Combine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
8 Posts
We have a 9670 with same problem need new short block. In hospital at current moment Deere is covering motor because it is still within two year warranty. Our dealer has done 3 9770 motors with same issue. 2 they were able to just shim sleeves to proper spec's and one needed new short block. Our 9670 needs new short block cause block is to far out off spec to just shim and stay within spec's. I was told deere had a problem with jig on early nine litre motors from factory not sure if problem is wide spred or not but there does appear to be a few out there.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top