The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Our sieve sensor has been unresponsive for the past couple of days. Has anyone else had this problem? I think this kind of goes with a previous post.
 

·
Registered
Joined
·
27 Posts
Discussion Starter #3
Sieve loss, it was not the sensor but the pad. John Deere replaced it yesterday. We have a neigbor that has had 5 sensors replaced on the sieves.
 

·
Registered
Joined
·
27 Posts
Discussion Starter #6
Watched JD mechanic change our pad for sensor. You can turn your key on without starting engine and go back and tap on the pads to see which one it is. They are both right above the axle on back of combine. Have someone tap on them while someone else sets in cab of combine to see if they register on the sieve loss on vision track monitor.
 
1 - 6 of 6 Posts
Top