The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,215 Posts
Discussion Starter #1
Wondering if you folks could answer a question for me: When/which model combines did MF add the header work lights (stubble lights) wiring? I know none of the combines prior to the single point had them, but were they on the late model 9x90 combines?

If any of you could chime in and say "I have a 9x90 w/single point and Dynaflex head and the stubble lights work" It would help me nail this down on our combine model spreadsheet!
 

·
Registered
Joined
·
1,215 Posts
Discussion Starter #4
FYI: After not getting much response here, I took a drive to a AGCO dealer who had a bunch of combines. I took along a test light! What I found was every AGCO with factory single point (MF 9895 & newer) has pin 20 on the single point connected to the lower work lights switch.
 
1 - 5 of 5 Posts
Top