The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
So combining corn, this message showed up, along with HMM 628.12 and
?f5 error. It shuts down my yield mapping. The odd part is that on occasion while the uploading auger in on it all will reconnect for 10-15 seconds. We have reprogramed the module. So is there anything else to check before replacing the entire moisture sensor?
 

Attachments

·
Registered
Joined
·
69 Posts
Discussion Starter · #4 ·
We tried everything we could think of to not replace the moisture sensor, but that needed up being the fix. There was a couple of DTAC messages that indicated a bad circuit board. But of course, you cannot buy just the circuit board. Its all new and working
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top