The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
maybe i just missed it but was looking in manual for info about moisture sensor....does it require lube, cleaning, etc? how often should you take it out of there...i cleaned it out from wheat to beans....its been off lately so i am thinking i have some green material possibly hung in there...thanks.
 

· Registered
Joined
·
80 Posts
Discussion Starter · #3 ·
i assume it is the bypass system too...05 2388 and its on the side of clean grain auger down at bottom...how does the system work? i assume the grain flows down through sensor and then the auger pushes it back into elevator...then as you mentioned the auger cleans it out when seporator stops..is that right?

got a few more question for you about the calibration process....just need to read the ops man again to clarify what i need to ask...thanks torn
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top