The Combine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
192 Posts
Discussion Starter · #1 ·
On the 60 series combine,if i use the number two button on joystick to control header height, I want to set the header height higher than is allowed on default. Can I change an address than will allow me to combine at higher heights, still used auto height,and contour master. we have alot of rocks in some fields,so we want to run it higher
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top