Re: Anybody put a 1020 header on a 50/60/7088 comb
We almost did and then chose not to. You will need to change the feeder face as well as reconfigure the electric and hydraulic connections. Seems to me it was going to cost over $8000 Cdn. Also you need to change the drive shaft ends because the new 88's have 540PTO type drive shaft, not hex shaft like the old ones.
We almost did and then chose not to. You will need to change the feeder face as well as reconfigure the electric and hydraulic connections. Seems to me it was going to cost over $8000 Cdn. Also you need to change the drive shaft ends because the new 88's have 540PTO type drive shaft, not hex shaft like the old ones.
