The Combine Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
399 Posts
Discussion Starter #1
My Raven Dealer says my Envizio Plus is not repairable if it fails. If it does fail, I am totally finished as I do not even have foam markers so I am looking for ideas. Are there any commonalities in wiring etc between this model and the Envizio Pro so as to save a bit on the conversion, or does a person just throw it all away and start over? Has anyone had any luck trading the old model in to Raven for a newer Envizio Pro, Raven is being very tight lipped about any such program if it exists.
Trimble had a trade in program to get the old model 500's off the street so I was hoping perhaps someone has weaseled a trade out of their Envizio Plus .
 
1 - 1 of 1 Posts
Top