The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
237 Posts
Discussion Starter · #1 ·
The augar drive slip clutch on my 1020 platform is starting to slip more than normal when I get into heavy cutting. C/IH says you can't replace the pads in theirs, and you have to buy the whole drive assembly new! Wow, kind of expensive! Anybody tried to take one of them apart and buy the parts to rebuild?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top