The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have a auger extension on a 9750 and the bearing is out so im going to put one in. Will I need to re time the auger with the verticsl auger since i pulled it out about a foot. Also does any one make auger extensions for a 9660 with small auger.
Thanks
 

·
Registered
Joined
·
20 Posts
if you are just pulling the very end one out just make sure you get it back in as close as you can to were you pulled it out.
 
1 - 2 of 2 Posts
Top