The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Anybody have any experience repairing floor on grainhead ? Existing floor has wore out .Will 1/8 th inch plastic make a good liner . This repair is for a neighbor that has a very limited budget . It is on an old series 2 head on a F.
 

·
Registered
Joined
·
597 Posts
We repaired the center of the floor on one of our L-2 pickup headers this fall. Had a piece of similar gauge rolled to shape and bolted to the old floor with sickle bolts, the kind with the pan head and fluted shoulder. Worked real well...
 

·
Registered
Joined
·
1,090 Posts
is there holes the full width, or is it just wore in the middle? if in the middle only, I would cut the pan at the first crossmember out on each side from the center, and put a new center sheet in.

I really wish these had a 3 piece pan from the factory, but oh well. :)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top