The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,246 Posts
Discussion Starter · #1 ·
I have a 7720 and a 7700 that need some patch work on the bottom shoe auger pan. At the very bottom below the shoe auger bearings I've patched a few holes over the years, but I have a couple that are towards the top of the bottom pan and It looks impossible to get to these holes. Any advice or expireance in patching these hard to reach holes?
 

·
Registered
Joined
·
69 Posts
I have patched holes on the top of the clean grain elevator on a 7700 using body filler. Get a quart can of short strand fiberglass body filler and a tube of hardener, mix the two together and apply as needed. Hardens in minutes and seems to stay.
 
1 - 2 of 2 Posts
Top